ALWAYS INNOVATING, NEVER DUPLICATING

Power Distribution

The MFC Offroad power distribution center is the key to an easy solution to all of your aftermarket wiring needs. No longer are you going to have to run relays, switches, unsightly wires in the engine bay, separate locations for all your fuses...the list is endless! This unit is the brains behind running all of your aftermarket lights and accessories. You simply mount the brain box in the engine bay in the custom location we have provided so no drilling is necessary! You can power 6 individual accessories and lights from the brain. You just run all of your accessories positive and negative wires to the desired posts inside the brain. From here, you then run the control wire through the firewall grommet and mount your switches where ever you want. Everything is pre-wired for your convenience.


Each system includes the following: All required mounting brackets and hardware. System will come pre-wired ready to install. Mounting bracket positions the unit next to the battery. Due to this, we engineered it to have multiple heights depending on if you are running the factory battery or aftermarket. This allows the unit to not come into contact with the battery.


Included: Six single light red Contura switches, (installed and pre-wired in MFC Offroad's console panel switch holder), two piece wire harness utilizing 18 gauge wires. Each end has an automotive connector.


All wires are wrapped in high temp abrasion resistant nylon braided sleeving, with heat shrink tubing on the ends.


MFC's 6 position power distribution system includes:


*6 locations utilizing positive & negative terminals for accessories

*6 automotive cube style relays (plug-in style and field replaceable)

*6 ATO style automotive fuses 3 15 amp and 3 30 amp supplied (plug-in style and field replaceable)

*Inline 80 amp manual resetting circuit breaker

*8 gauge power leads with crimped and soldered terminal for connection to the battery (positive/negative)

*Integrated LVCO (Low-Voltage-Cut-Off) circuit that detects the battery voltage and will cut-off at 10.6VDC and cuts-back in at 12.4VDC so there is enough juice to start your vehicle in case you left an accessory on!!!

*Fuse for LVCO which can be removed to bypass the LVCO

*Custom brain mounting bracket for 14+ Jeep Cherokees only





*** CLICK LOGO BELOW FOR INSTALLATION INSTRUCTIONS ***